Compare

Bare Knuckle Polypaf vs Seymour Duncan Full Shred (SH-10)

We found no spec differences between them worth calling out.

Specs side by side

differs marks specs where they part ways
SpecBare Knuckle PolypafSeymour Duncan Full Shred (SH-10)
DC resistancediffers7.6k7.4k
Inductancediffers4.15 H (measured, 1 reading)not measured
MagnetAlnico 5Alnico 5
CoilHum-cancellingHum-cancelling
Resonant peakdiffers—8 kHz (Seymour Duncan's own test load)
Bass (tone chart)Each maker grades its own chart, so read these within a brand4 / 104 / 10
Mids (tone chart)differsEach maker grades its own chart, so read these within a brand6 / 104 / 10
Treble (tone chart)differsEach maker grades its own chart, so read these within a brand7 / 108 / 10
Slotneck humbuckerneck humbucker
Traitsvintage output, tight lowsvintage output, tight lows

How close on each spec

100 means identical on that spec. The score weighs these, and counts anything we couldn't compare as a typical difference. How scoring works

Output
96
DC resistance (no inductance for one of them)
Magnet
100
both Alnico 5
Coil
100
same coil type
Brightness
71
each against its maker's average
Mids
69
each against its maker's average
Bass
91
each against its maker's average

Videos

Bare Knuckle Polypaf

Seymour Duncan Full Shred (SH-10)

Seymour Duncan Full Shred Pickups Demo (Bridge & Neck)
Osman Cenan Çiğil
Seymour Duncan Distortion VS Full Shred | Ibanez RG2820CTVV and Orange Jim Root #4
RolanTHUNDER · comparison

What players and reviewers say

On the Seymour Duncan Full Shred (SH-10)

“The Full Shred is a tad lower in output and gets close to the lead sound of a JB.”
El SupremoSeymour Duncan forum ↗ (opens in a new tab)
“A Full Shred sounds very nice in that guitar, similar to a Strat lead pickup but much hotter and more full sounding on the low end.”
dystrust · 2004-04-12Seymour Duncan forum ↗ (opens in a new tab)
Everything on the Seymour Duncan Full Shred (SH-10) →

Full reviews