Closest match
no spec differences found
No inductance for one of them, so output leans on DC resistance; tone charts compared directly.
high confidence
Seymour Duncan
Seymour Duncan Full Shred (SH-10)
A neck humbucker with an Alnico 5 magnet and vintage output.
vintage outputtight lows
Specs
- DC resistance
- 7.4k
- Inductance
- not measured
- Magnet
- Alnico 5
- Coil
- Hum-cancelling
- Resonant peak
- 8 kHzSeymour Duncan's own test load
From Seymour Duncan's published specs ↗ (opens in a new tab). Traits come from these specs by stated rules.
Also in the set
Similar pickups
230 fit the same slot · ranked on measured specs · top 40 shownUpgrading from the Seymour Duncan Full Shred (SH-10)? Put it on the map and see what sits where you want your tone to go.
Each score is how close a pickup is on measured specs, out of 100. The meter shows how many of those specs we could compare; a grey score means few could be. Filters cover the top 40. How scoring works
- Compare →
darker
No inductance for one of them, so output leans on DC resistance; tone charts compared directly.
Compare →high confidenceno spec differences found
No inductance for one of them, so output leans on DC resistance; tone charts compared against each maker's average.
Compare →medium confidenceno spec differences found
No inductance for one of them, so output leans on DC resistance; tone charts compared against each maker's average.
Compare →medium confidenceno spec differences found
No inductance for one of them, so output leans on DC resistance; tone charts compared against each maker's average.
Compare →medium confidencedarker · more bass
No inductance for one of them, so output leans on DC resistance; tone charts compared directly.
Compare →high confidence
What others say
Demos, reviews and forum posts, quoted word for word and linked to where they were published. No videos collected yet.
“With less in the lows and mids and plenty in the highs, it's going to cut through.”
“You might still get a little grit on clean amp settings, but it gets nice and glassy when the coils are split.”
“The Full Shred is a tad lower in output and gets close to the lead sound of a JB.”
Comparing with Seymour Duncan JB Model (SH-4)
Played the Seymour Duncan Full Shred (SH-10)?
Tell other players how it sounds in your guitar. These are visitors' own comments: checked for spam before they appear, but not fact-checked like the sourced quotes above.
Loading comments…