Compare
Seymour Duncan Full Shred (SH-10) vs Seymour Duncan Original Parallel Axis (PATB-1)
Seymour Duncan Full Shred (SH-10)
neck humbucker
88 match
high confidence
Seymour Duncan Original Parallel Axis (PATB-1)
neck humbucker
Compared with the Seymour Duncan Full Shred (SH-10), the Seymour Duncan Original Parallel Axis (PATB-1) has a darker top end.
Specs side by side
differs marks specs where they part ways| Spec | Seymour Duncan Full Shred (SH-10) | Seymour Duncan Original Parallel Axis (PATB-1) |
|---|---|---|
| DC resistancediffers | 7.4k | 7.5k |
| Inductance | not measured | not measured |
| Magnet | Alnico 5 | Alnico 5 |
| Coil | Hum-cancelling | Hum-cancelling |
| Resonant peakdiffers | 8 kHz (Seymour Duncan's own test load) | 6.9 kHz (Seymour Duncan's own test load) |
| Bass (tone chart)differs | 4 / 10 | 5 / 10 |
| Mids (tone chart) | 4 / 10 | 4 / 10 |
| Treble (tone chart)differs | 8 / 10 | 7 / 10 |
| Slot | neck humbucker | neck humbucker |
| Traits | vintage output, tight lows | vintage output |
How close on each spec
100 means identical on that spec. The score weighs these, and counts anything we couldn't compare as a typical difference. How scoring works
Output
98
DC resistance (no inductance for one of them)
Magnet
100
both Alnico 5
Coil
100
same coil type
Brightness
57
tone charts on the same scale
Mids
100
tone charts on the same scale
Bass
83
tone charts on the same scale
Videos
No videos for either pickup collected yet.
What players and reviewers say
On the Seymour Duncan Full Shred (SH-10)
“The Full Shred is a tad lower in output and gets close to the lead sound of a JB.”
Comparing with Seymour Duncan JB Model (SH-4)
“With less in the lows and mids and plenty in the highs, it's going to cut through.”
On the Seymour Duncan Original Parallel Axis (PATB-1)
“The high end sings with an edgy sweetness that has bite without being shrill.”
“The upper mids and the high end are more about clarity, so notes are more precise and less nasal on the high end.”